ESI IVX 128 Installation Manual download pdf (Page 13)

IVX 128 Plus: additional features

What happens now depends upon whether the system detects DTMF from the called party:

• If it does, the system completes the trunk-to-trunk connection.

• If it doesn’t, the system forwards the call to the programmed call forwarding for this outdial

branch (the next step for which you’re prompted if DTMF detection is required).

Note: You’ll be prompted to enter a call forwarding destination for an outdial branch only if

(a.) the branch uses trunk-to-trunk and (b.) DTMF detection is required.

Enter an extension, branch ID or mailbox number for the day/night call forwarding of

this GoTo Outdial branch.

Note: While both COs are connected, the system constantly monitors the lines for open loops. If it

detects an open loop on either line, it terminates both CO connections. Additionally, the

system periodically will monitor for voice on the connected COs. If it detects no voice traffic,

it terminates both CO connections. Finally, if both COs are connected for a period

(programmable; default is 60 minutes), the system will terminate the connection, regardless

of the presence or absence of activity.

Function 43: Automatic day/night mode table

What’s new: A second day mode and a second night mode.

The ability to re-record ID1 remotely.

You program the day/night mode table by selecting the day of the week, then entering the start time,

and then selecting the mode — day, night, day2 or night2. At the time you’ve programmed, the

appropriate greeting for that mode will play and the system will follow the appropriate day or night

forwarding. Day forwarding is the same for both day mode and day2 mode; night forwarding is the

same for both night mode and night2 mode. Enter the times in military time (0000–2359). Each day

can have up to six different times.

Select the day of the week by pressing a scroll (▼ or ▲) key.

Press # to confirm.

Enter the day’s start time in 24-hour format.

Press # to confirm.

Select the mode — day, night, day2 or night2 — by pressing a scroll (▼ or ▲) key.

Press # to confirm.

Repeat steps 3–6 for the day’s next setting or press # again to program another day.

When finished, press # again to exit.

Note: To delete an entry, press HOLD.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

ESI IVX 128 Installation Manual Page 13