ESI 24-Key Digital Feature Phone Installation Manual download pdf (Page 11)

IVX C-Class Installation Manual Hardware overview/installation

B.5

Opening the cabinet

The lid on all cabinets is held in place by two tabs that rest in slots in the bottom of

the case, and a release tab that snaps into an opening in the top-center of the

cabinet and is secured by a retaining screw.

To remove the lid:

1. Remove the retaining screw and depress the release tab at the top of

the cabinet.

2. Rock the lid back from the top.

3. Lift and pull the lid free from the slots in the bottom of the cabinet.

Mounting the cabinet

Use three #8 hex-head screws. Note the position of the three mounting holes in the IVX cabinet.

1. Screw in the top screw to the backboard (at least half-inch thick

plywood) leaving about one-eighth-inch clearance between the

screw head and the plywood.

2. Hang the unit using the keyhole at the top of the case.

3. Level the unit and install the bottom two screws.

Attach the power transformer to the wall, allowing sufficient length in

both cords to reach the power connector on the upper right side of

the cabinet and to reach a UPS or a dedicated 110 VAC outlet.

Memory Module

Note: The Memory Module has a proprietary formatting scheme — do not attempt to install a non-ESI

CompactFlash. Contact ESI for a replacement Memory Module, if needed.

Adding or replacing the Memory Module will require that the system be powered down.

Replacing the Memory Module erases all its configuration data and custom recordings.

(Prompts stay intact, however.)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

No comments

ESI 24-Key Digital Feature Phone Installation Manual Page 11