Esi Waveterminal U24 User Manual download pdf

U2A/U24 Exclusive driver installation in Windows XP

1. Installation

If the hardware installation was done properly, your computer will look for the Windows

native drivers need to use U2A or U24 and start to install them.

After Windows native driver was done properly, you must keep going to next exclusive

U2A/U24 driver.

1. Insert the provided Driver CD or diskette into the CD-Rom drive or floppy disk

drive and (or unzip U2A zip file and) copy all the files to a folder at your hard disk.

Name it whatever you like. Do not move or delete any of these files, not even after

the installation. Run “setup” icon.

After that, if you see below message, simply click “Yes”

1 2 3 4 5 6 ... 12 13

U2A/U24 Exclusive driver installation in Windows XP 1. Installation If the hardware installation was done properly, your computer will look for the W

Page 2

8. After rebooting your computer, open your system’s Device Manager and confirms that “Waveterminal U2A/U24” is shown under “Universal Serial Bus Con

Page 3

2-1. Launching MME Control Panel After exclusive U24/U2A driver was done properly, unzip ‘U2xpanel.zip’ to your computer. 'U2xpan.exe' will

Page 4

3. Control Panel Reference MME & ASIO This control panel is pretty simple. However you should be careful with ‘System performance’ in Dithering

Page 6

, 2. Check ‘I accept the agreement’ and click “Install”. 3. Exclusive U2A/U24 driver will be installed. 2

Page 7

4. Click “Reboot now” 5. After install the software, Go to Device Manager again. If your windows is 2000, ME or 98SE, you finished setting. But if

Page 8

6. Right mouse click and click Properties. 4

Page 9

7. Click “update Driver”. 8. Choose “Install from a list or specific locations”. 5

Page 10

9. Choose “Don’t search. I will choose the driver to install”. 10. Choose ‘Waveterminal U24(or U2A)’ 6

Page 12

Page 13

Esi Waveterminal U24 User Manual