ESI MaXiO series Specifications download pdf (Page 9)

MaXiO series System Manual

can be amplified with 48dB maximum, line level signals with up to 30dB.

Analog Input / Output Level Meter

The two level meters indicate the signal level for the analog inputs and outputs. The level meter

on the left shows the input signal; the level meter on the right shows the output signal of the

corresponding channel. A range from 0dB to 60dB in 10 dB-steps is displayed.

2.2.2 Front Panel Power Section

Power Indicator LED

Power Switch

Phantom Power Switch

+48V DC phantom power (for balanced condenser microphones) will be

supplied via every XLR input connector when this button is enabled.

Note that this affects only those input channels that are set to receive

microphone signals (check ).

· Before you turn on the phantom power switch, you must make sure to connect your

microphones to the XLR inputs (with balanced cables).

· After you have turned on the phantom power switch, you should not connect or

disconnect a microphone to any of the input connectors.

2.2.3 Back Panel Power Section

AC IN

EX8000 needs external AC power. It supports 100~240V AC (free voltage). There

is a spare fuse (5X20mm Glass Fuse) below the connector.

2.2.4 Front Panel Clock & Control Section

Clock Source Indicator

Displays the current clock source of EX8000:

- Internal: EX8000 uses its internal clock.

- External: EX8000 works with the clock from the Word Clock input.

- Digital In: EX8000 works with the clock supplied from the AES/EBU,

S/PDIF or ADAT input.

- E.D.I: EX8000 works with the clock from the MaXiO PCI/PCIe

host card.

Clock Frequency Indicator

Displays the current sample rate of EX8000.

Clock Select Button 1

When EX8000 is working in stand alone mode, you can choose the

clock source with this button (Internal, External, Digital In). This

function is not available when EX8000 is connected to the MaXiO

CAUTION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 52 53

No comments

ESI MaXiO series Specifications Page 9