Esi MI/ODI/O User Manual download pdf

MI/ODI/O add-on card

Owner’s manual

The MI/ODI/O has one Coaxial Input/Output, one Optical digital Input and

16 channels MIDI Input/Output.

The MI/ODI/O is designed to be used with the Waveterminal 192 series of

audio cards as an add-on. It’s easy to install and does not require any

additional power supply or drivers to install. No new IRQ set up involved.

The MI/ODI/O has one Coaxial Input/Output, one Optical digital Input and

16 channels MIDI Input/Output. The MI/ODI/O lets you get more from

your Waveterminal 192 series by adding the power of S/PDIF In and Out

and MIDI I/O.

MI/ODI/O driver already included in EWDM driver of Waveterminal 192

series. Therefore, by the installation of the driver of Waveterminal 192

series, you can use MI/ODI/O right away.

Just hook it up to your Waveterminal 192 card like a below picture and

you're ready to go!

1. To install the MI/ODI/O in your computer

1.Turn off the computer power and remove the cover.

2.You require one empty slot close to the Waveterminal 192 series.

3.Connect the MI/ODI/O connection cable to the Waveterminal 192

connector. The cable can be connected only one way.

4. Place the MI/ODI/O into the empty slot. Be careful not to touch other

cards to avoid any damage to the cards.

1 2 3 4

1MI/ODI/O add-on card Owner’s manual The MI/ODI/O has one Coaxial Input/Output, one Optical digital Input and 16 channels MIDI Input/Output. The M

25. Tighten the screw using proper tool. 6. Check to see if the MI/ODI/O is in place firmly. 2. MI/ODI/O add on card 1. SPDIF Optical Input (24bi

Page 3

3support 192kHz in specification, we got the reports shows possibility while we were testing. However, it heavily depends on system environment, It m

44. 5. In, Out – MIDI In/Out display When MIDI signal flows through MI/ODI/O, This LED will be blinking. 6. PWR It is MI/ODI/O power LED(Indicator).

No comments

Esi MI/ODI/O User Manual